ENF to NX I-deas

Section Name [ENF2IDEAS]

CalcElementNumber

Output the element number in XML log

  • Default Value: 0
  • Values
    • 0: OFF
    • 1: ON

CalcMassProperty

Output mass properties (Volume, Surface area, gravity) in XML log.

  • Default Value: 0
  • Values
    • 0: OFF
    • 1: ON

ConvertInvisibleInstance

Specify whether to translate hidden instances

  • Default Value: 1
  • Values
    • 0: Don’t translate hidden instances
    • 1: Translate hidden instances as shown instances
    • 2: Translate hidden instances as hidden instances

ProductMode

Specify whether to apply CADdoctor default setting

  • Default Value: 0
  • Values
    • 0: ASFALIS mode
    • 1: CADdoctor mode

StitchOption

Specify whether to stitch surfaces after converting to NX I-deas.

  • Default Value: 0
  • Values
    • 0: Don’t stitch surfaces
    • 1: Stitch surfaces

SurfaceExtend

Specify the option of cleaner of I-deas

  • Default Value: 0
  • Values
    • 0: Normal
    • 1: No Extend

UseTightTolForPlane

Set the tolerance of processing approximated the surface to the plane.

  • Default Value: 2
  • Values
    • 0: 0.01mm
    • 1: 0.005mm
    • 2: 0.0001mm

XConvertDimension

Specify whether to convert Dimension. (Annotation)

  • Default Value: 0
  • Values
    • 0: Don’t convert Dimension
    • 1: Convert Dimension

XConvertGDT

Specify whether to convert GDT, Datum, DatumTarget. (Annotation)

  • Default Value: 0
  • Values
    • 0: Don’t convert GDT
    • 1: Convert GDT

XConvertLineWeld

Specify whether to convert LineWeld. (Annotation)

  • Default Value: 0
  • Values
    • 0: Don’t convert Line Weld
    • 1: Convert Line Weld

XConvertLocator

Specify whether to convert Locator. (Annotation)

  • Default Value: 0
  • Values
    • 0: Don’t convert Locator
    • 1: Convert Locator

XConvertMaterial

Specify whether to convert Material. (Attribute)

  • Default Value: 0
  • Values
    • 0: Don’t convert Material
    • 1: Convert Material

XConvertNote

Specify whether to convert Note. (Annotation)

  • Default Value: 0
  • Values
    • 0: Don’t convert Note
    • 1: Convert Note

XConvertSpotWeld

Specify whether to convert SpotWeld. (Annotation)

  • Default Value: 0
  • Values
    • 0: Don’t convert Spot Weld
    • 1: Convert Spot Weld

XConvertSurfFinish

Specify whether to convert SurfaceFinish. (Annotation)

  • Default Value: 0
  • Values
    • 0: Don’t convert SurfaceFinish
    • 1: Convert SurfaceFinish

XConvertSystemProperty

Specify whether to convert system properties. (Attribute)

  • Default Value: 0
  • Values
    • 0: Don’t convert system properties
    • 1: Convert system properties

XConvertUserProperty

Specify whether to convert user properties. (Attribute)

  • Default Value: 0
  • Values
    • 0: Don’t convert user properties
    • 1: Convert user properties