|
2. Exiting the Program |
| Typical Exit | |
| To exit CADdoctor for NX (Check-Mate), click the [Close] button in the Check-Mate dialog box. | |
|
| Terminating the Program | |
| Halting diagnostics of the current part | |
|
If necessary, you can halt diagnostics of the current part by clicking the [Cancel] button on the following progress indicator displayed by CADdoctor for NX. If you are diagnosing multiple parts, diagnostics will resume with the part after the part at which diagnostics was canceled. |
|
 |
|
| Aborting the session | |
|
If necessary, you can terminate the Check-Mate session by clicking the [Stop] button on the following progress indicator displayed by NX. If you are diagnosing multiple parts, the Check-Mate session will end after it finishes diagnosing the part being diagnosed when you clicked the Check-Mate [Stop] button. |
|
 |