1.License Setting

Procedure

	Select [CADdoctor for NX Tools] tab > [Set Elysium License] from the ribbon menu, and "License Client Setting" dialog appears. You can see how to set the license password, and how to install the "Elysium License Management Program" by a separate volume "Sentinel RMS License Manager Setup & Quick Start Guide".
	1. Make sure that the following items are set in the "License Client Setting" dialog (Floating). ・ Server Name: the machine name (host name) that is installed the Elysium License Management Program ・ Port Number: the port number specified when you applied for your license ("5093" as the default)
	2. In addition, you can also use Node Lock (the client machine is fixed). Check "Node Lock" and specify the license password file in this case. 3. In addition, you can also use Commuter (the client license is taken out). Check "Commuter". * Try setting the license again according to the separate volume "Sentinel RMS License Manager Setup & Quick Start Guide" if the above are not set correctly.