For general Check-Mate operating instructions, please refer to the Check-Mate manual provided with NX.

	Start the program as follows:
	1. Startup NX by the menu [start] - [Programs] - [CADdoctor for NX] - [Start NX], and NX is activated.
	2.Import the file(s) to diagnose.
	3.To start Check-Mate, click on the NX toolbar (or select [Analysis] - [Check-Mate] - [Set Up Tests] from the menu).
	(If the Check-Mate button does not appear on the toolbar, right-click the toolbar and select [Check-Mate].) Or run the following command manually from HD3D tool at the left of NX user interface. - [Check-Mate] > [Settings] > [Set Up Tests]
	The following Check-Mate dialog box appears.
	Use this main dialog box to perform parts diagnostics.